Fire near Bellegarde-en-Diois

What the satellites measured

This fire was tracked from 10 August at 03:13 to 12 August at 02:37, that is 2 days, through 30 satellite detections. The detected extent reaches 210 ha.

Detected extent

210 ha

Cumulative power

124 MW

Peak power, one pixel

14 MW

VIIRS and MODIS detections

30

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Timeline

Closed, no update320 hastarted on 8 August at 19:37 · contained on 18 August at 07:44 · closed with no update, on 22 August at 11:10

1. Reported contained18 August at 07:44

   Apres deux semaines de lutte contre les flammes, l'incendie de Bellegarde en Diois est désormais fixé · ici.fr

2. Reported extinguished17 August at 11:33
3. First report8 August at 19:37

   320 hectares brûlés, des reprises de feu sur l'incendie de Bellegarde-en-Diois · ici.fr

A "contained" fire is no longer spreading but is not out: crews remain on site and it can flare up again. Statuses and areas come from press reports and official sources, matched automatically; they are not an official record : only the prefecture and the fire service are authoritative. An entry with no news for ten days is closed automatically, and each entry's history keeps track of who announced what, and when.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

The detected extent

Before, after: the burn scar seen from space

Before · 6 August 2026After · 19 August 2026

Sentinel-2, 10 m resolution. The dates are those of the least cloudy passes available: “after” is not the day after the fire went out, it is the first clear sky that followed. Contains modified Copernicus Sentinel-2 data (2026).

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 4 days; beyond that, clustering would merge two successive fires in the same place.

Satellite passes in detail

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.