Fire near Bengo (AO)
9.73°S, 13.89°E · first detected on 30 September at 14:04
What the satellites measured
This fire was tracked from 30 September at 14:04 to 14 October at 14:42, that is 14 days, through 406 satellite detections. The detected extent reaches 12,575 ha.
- Detected extent
- 12,575 ha
- Cumulative power
- 11,102 MW
- Peak power, one pixel
- 439 MW
- VIIRS and MODIS detections
- 406
- Estimated emissions
- 15.3 kt of carbon
- Carbon burnt in the 0.1 degree cells (about 10 km) around the fire, from 5 October 2026 to 14 October 2026. An order-of-magnitude estimate from GFAS (ECMWF, Copernicus CAMS): it also counts neighbouring fires in the same cell. Contains modified Copernicus Atmosphere Monitoring Service information (2026).
These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.
“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.
Replay how the fire spread
The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.
How the radiative power evolved
One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 17 days; beyond that, clustering would merge two successive fires in the same place.
Fire dynamics
Loading history…
Satellite passes in detail
| Pass | Power summed over the pass | Detections | Sensor |
|---|---|---|---|
| 14 October at 14:42 | 6 MW | 1 | N |
| 14 October at 14:06 | 37 MW | 2 | N21 |
| 13 October at 17:09 | 357 MW | 4 | Aqua |
| 13 October at 15:01 | 23 MW | 2 | N |
| 13 October at 14:23 | 6 MW | 1 | N21 |
| 12 October at 16:31 | 16 MW | 1 | Aqua |
| 12 October at 15:21 | 69 MW | 4 | N |
| 12 October at 14:44 | 63 MW | 3 | N21 |
| 11 October at 15:38 | 3 MW | 1 | N |
| 11 October at 14:17 | 6 MW | 1 | N20 |
| 10 October at 16:54 | 696 MW | 13 | Aqua |
| 10 October at 15:22 | 11 MW | 2 | N21 |
| 10 October at 14:38 | 49 MW | 9 | N20 |
| 10 October at 14:19 | 21 MW | 2 | N |
| 10 October at 13:40 | 52 MW | 2 | N21 |
| 9 October at 16:16 | 377 MW | 2 | Aqua |
| 9 October at 14:55 | 294 MW | 13 | N20 |
| 9 October at 14:36 | 199 MW | 11 | N |
| 9 October at 14:00 | 46 MW | 8 | N21 |
| 8 October at 17:16 | 188 MW | 4 | Aqua |
| 8 October at 15:14 | 23 MW | 6 | N20 |
| 8 October at 14:55 | 76 MW | 9 | N |
| 8 October at 14:17 | 29 MW | 4 | N21 |
| 7 October at 16:40 | 690 MW | 9 | Aqua |
| 7 October at 15:33 | 180 MW | 10 | N20 |
| 7 October at 15:14 | 213 MW | 10 | N |
| 7 October at 14:38 | 362 MW | 7 | N21 |
| 7 October at 13:51 | 6 MW | 1 | N20 |
| 5 October at 17:01 | 594 MW | 13 | Aqua |
| 5 October at 15:14 | 22 MW | 4 | N21 |
| 4 October at 16:25 | 232 MW | 5 | Aqua |
| 4 October at 14:49 | 64 MW | 2 | N20 |
| 4 October at 14:29 | 27 MW | 2 | N |
| 3 October at 17:24 | 39 MW | 1 | Aqua |
| 2 October at 16:44 | 571 MW | 11 | Aqua |
| 2 October at 15:27 | 658 MW | 21 | N20 |
| 2 October at 15:08 | 476 MW | 19 | N |
| 2 October at 14:32 | 430 MW | 13 | N21 |
| 2 October at 13:47 | 121 MW | 6 | N20 |
| 30 September at 17:07 | 64 MW | 2 | Aqua |
| 30 September at 15:08 | 109 MW | 12 | N21 |
| 30 September at 14:23 | 70 MW | 8 | N20 |
| 30 September at 14:04 | 11 MW | 3 | N |
8 other fires near Bengo (AO)
Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.
Follow live
The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.
Open the fire mapTake the data of this fire with you
A ready-to-use archive, paid once, no subscription. It contains:
- the satellite detections of the fire
- the contours of its progression
- the drops and the aircraft tracks
- the lightning around it
- the severity of the burned area, when computed
From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.
Download the dataPro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro
© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.