Fire near Campeche (MX)

18.64°N, 92.17°W · first detected on 9 October at 09:41

Permanent heat source, probably industrial: this is not a forest fire. A site that heats up day after day in the same place (factory, gas flare, steelworks, oil field) is seen by satellites as a hotspot. This page stays available, but this hotspot is counted neither in the list of the largest fires nor in the hectare totals.

What the satellites measured

This fire was tracked from 9 October at 09:41 to 22 October at 22:25, that is 14 days, through 85 satellite detections. The detected extent reaches 227 ha.

Detected extent
227 ha
Cumulative power
374 MW
Peak power, one pixel
14 MW
VIIRS and MODIS detections
85

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 16 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
22 October at 22:259 MW2N
22 October at 21:494 MW1N21
22 October at 21:063 MW1N20
22 October at 20:4515 MW4N
22 October at 10:393 MW1N21
22 October at 09:564 MW3N20
22 October at 09:351 MW1N
22 October at 08:589 MW2N21
21 October at 21:2510 MW1N20
21 October at 21:0528 MW2N
20 October at 20:472 MW1N21
17 October at 21:452 MW1N21
17 October at 20:5917 MW3N20
17 October at 20:4025 MW4N
17 October at 09:509 MW2N20
16 October at 09:483 MW2N
15 October at 21:198 MW1N
15 October at 20:417 MW1N21
15 October at 10:265 MW3N20
15 October at 10:077 MW3N
15 October at 09:299 MW3N21
14 October at 21:557 MW1N20
14 October at 20:598 MW2N21
14 October at 12:024 MW1Aqua
14 October at 10:456 MW4N20
14 October at 10:266 MW2N
14 October at 09:504 MW2N21
14 October at 09:032 MW1N20
13 October at 21:554 MW1N
13 October at 20:3422 MW2N20
12 October at 20:5312 MW2N20
12 October at 16:4812 MW1Terra
12 October at 10:2622 MW4N21
12 October at 09:418 MW2N20
11 October at 10:0110 MW1N20
11 October at 09:418 MW1N
11 October at 09:0414 MW6N21
10 October at 23:3810 MW1Aqua
10 October at 10:2012 MW3N20
10 October at 10:019 MW3N
10 October at 09:2412 MW2N21
9 October at 09:413 MW1N21

One other fire near Campeche (MX)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2