Fire near Chaco (AR)

25.77°S, 61.20°W · first detected on 16 October at 19:05

What the satellites measured

This fire was tracked from 16 October at 19:05 to 22 October at 07:29, that is 6 days, through 90 satellite detections. The detected extent reaches 490 ha.

Detected extent
490 ha
Cumulative power
634 MW
Peak power, one pixel
69 MW
VIIRS and MODIS detections
90
Estimated emissions
4.4 kt of carbon
Carbon burnt in the 0.1 degree cells (about 10 km) around the fire, from 16 October 2026 to 21 October 2026. An order-of-magnitude estimate from GFAS (ECMWF, Copernicus CAMS): it also counts neighbouring fires in the same cell. Contains modified Copernicus Atmosphere Monitoring Service information (2026). Published data stop on 21 October 2026.

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 8 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
22 October at 07:293 MW1N21
22 October at 06:464 MW2N20
21 October at 14:4012 MW1Terra
21 October at 07:4843 MW13N21
21 October at 07:0432 MW12N20
21 October at 06:4417 MW8N
21 October at 04:5212 MW1Met12
21 October at 04:1217 MW1Met12
21 October at 04:0217 MW1Met12
21 October at 03:4213 MW1Met12
21 October at 03:3216 MW1Met12
21 October at 03:2216 MW1Met12
21 October at 03:1219 MW1Met12
21 October at 02:5217 MW1Met12
21 October at 02:1214 MW1Met12
21 October at 01:3215 MW1Met12
21 October at 01:3023 MW1G19
21 October at 01:2232 MW2Met12
21 October at 01:1237 MW2Met12
21 October at 01:1022 MW1G19
21 October at 00:5219 MW1Met12
21 October at 00:5022 MW1G19
21 October at 00:4214 MW1Met12
21 October at 00:2023 MW1G19
20 October at 23:2043 MW1G19
20 October at 23:0054 MW1G19
20 October at 22:5051 MW1G19
20 October at 22:1048 MW1G19
20 October at 22:0049 MW1G19
20 October at 21:5064 MW1G19
20 October at 21:4071 MW1G19
20 October at 21:3224 MW1Met12
20 October at 21:2057 MW1G19
20 October at 21:1069 MW1G19
20 October at 21:0076 MW1G19
20 October at 20:5070 MW1G19
20 October at 20:1090 MW1G19
20 October at 20:0094 MW1G19
20 October at 19:4925 MW5N20
20 October at 19:30144 MW6N
20 October at 17:2079 MW1G19
20 October at 17:1254 MW1Met12
20 October at 17:02102 MW2Met12
20 October at 17:0084 MW1G19
20 October at 16:5255 MW1Met12
20 October at 16:4254 MW1Met12
20 October at 16:2230 MW1Met12
20 October at 16:2053 MW1G19
20 October at 08:0252 MW2Met12
20 October at 07:5267 MW3Met12
20 October at 07:4772 MW3G19FRP
20 October at 07:4267 MW3Met12
20 October at 07:3758 MW3G19FRP
20 October at 07:3239 MW2Met12
20 October at 07:2771 MW3G19FRP
20 October at 07:2378 MW14N20
17 October at 08:206 MW4N20
17 October at 07:597 MW3N
17 October at 07:237 MW5N21
17 October at 06:404 MW1N20
17 October at 02:488 MW1Terra
16 October at 20:4565 MW4N
16 October at 20:0969 MW1N21
16 October at 19:2459 MW5N20
16 October at 19:0552 MW4N

7 other fires near Chaco (AR)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2