Fire near Gibellina (IT)

37.85°N, 12.93°E · first detected on 11 September at 13:34

What the satellites measured

This fire was tracked from 11 September at 13:34 to 18 September at 16:18, that is 7 days, through 19 satellite detections. The detected extent reaches 765 ha.

Detected extent
765 ha
Cumulative power
123 MW
Peak power, one pixel
24 MW
VIIRS and MODIS detections
19

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 10 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
18 September at 16:187 MW1Aqua
16 September at 02:181 MW2N
15 September at 16:017 MW1Aqua
15 September at 13:212 MW1N21
14 September at 14:3819 MW2N20
11 September at 15:1417 MW2N
11 September at 13:342 MW1N
10 September at 16:1083 MW3Aqua
10 September at 14:1228 MW6N20
10 September at 13:5118 MW5N
10 September at 13:1721 MW3N21

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.3.0