Fire near Jilin (CN)

43.43°N, 125.90°E · first detected on 10 November at 01:45

What the satellites measured

This fire was tracked from 10 November at 01:45 to 22 November at 06:01, that is 12 days, through 212 satellite detections. The detected extent reaches 3,815 ha.

Detected extent
3,815 ha
Cumulative power
1,219 MW
Peak power, one pixel
49 MW
VIIRS and MODIS detections
212
Estimated emissions
569 t of carbon
Carbon burnt in the 0.1 degree cells (about 10 km) around the fire, from 10 November 2026 to 21 November 2026. An order-of-magnitude estimate from GFAS (ECMWF, Copernicus CAMS): it also counts neighbouring fires in the same cell. Contains modified Copernicus Atmosphere Monitoring Service information (2026). Published data stop on 21 November 2026.

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 15 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
22 November at 06:0174 MW8N21
22 November at 05:21111 MW21N20
22 November at 04:2118 MW3N21
21 November at 04:403 MW1N21
20 November at 04:5915 MW3N21
18 November at 05:3818 MW3N21
17 November at 05:55171 MW33N21
17 November at 05:12230 MW45N20
16 November at 05:313 MW1N20
13 November at 08:0913 MW1Aqua
13 November at 06:2719 MW3N20
13 November at 05:3133 MW5N21
13 November at 04:492 MW1N20
12 November at 18:062 MW2N21
12 November at 07:3128 MW1Aqua
12 November at 05:5065 MW3N21
12 November at 05:0617 MW5N20
11 November at 18:263 MW1N21
11 November at 05:2520 MW5N20
10 November at 07:5421 MW2Aqua
10 November at 05:445 MW2N20
10 November at 01:4514 MW1Terra

8 other fires near Jilin (CN)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2