Fire near Santiago del Estero (AR)

28.30°S, 62.84°W · first detected on 15 October at 21:04

What the satellites measured

This fire was tracked from 15 October at 21:04 to 22 October at 07:29, that is 6 days, through 49 satellite detections. The detected extent reaches 1,013 ha.

Detected extent
1,013 ha
Cumulative power
592 MW
Peak power, one pixel
68 MW
VIIRS and MODIS detections
49
Estimated emissions
2.9 kt of carbon
Carbon burnt in the 0.1 degree cells (about 10 km) around the fire, from 15 October 2026 to 21 October 2026. An order-of-magnitude estimate from GFAS (ECMWF, Copernicus CAMS): it also counts neighbouring fires in the same cell. Contains modified Copernicus Atmosphere Monitoring Service information (2026). Published data stop on 21 October 2026.

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 9 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
22 October at 07:293 MW2N21
22 October at 02:458 MW1Terra
21 October at 22:2789 MW2G19FRP
21 October at 22:17146 MW4G19FRP
21 October at 22:0885 MW3Aqua
21 October at 21:57188 MW4G19FRP
21 October at 20:5123 MW2N
21 October at 18:0048 MW1G19
20 October at 20:32186 MW4N21
20 October at 20:32161 MW2Met12
20 October at 20:20330 MW3G19
20 October at 20:10117 MW1G19
20 October at 20:00117 MW1G19
20 October at 07:233 MW1N20
20 October at 03:058 MW1Terra
19 October at 22:3267 MW2Aqua
19 October at 20:098 MW1N20
16 October at 22:1710 MW1Aqua
16 October at 20:0911 MW2N21
16 October at 19:2416 MW3N20
16 October at 14:4263 MW3Terra
16 October at 08:203 MW2N
16 October at 07:4210 MW7N21
16 October at 06:577 MW3N20
16 October at 06:406 MW5N
15 October at 21:3840 MW1Aqua
15 October at 21:0437 MW5N

8 other fires near Santiago del Estero (AR)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2