Fire near Tete (MZ)

16.41°S, 32.27°E · first detected on 7 October at 13:32

What the satellites measured

This fire was tracked from 7 October at 13:32 to 22 October at 14:10, that is 15 days, through 114 satellite detections. The detected extent reaches 1,826 ha.

Detected extent
1,826 ha
Cumulative power
929 MW
Peak power, one pixel
91 MW
VIIRS and MODIS detections
114
Estimated emissions
2.6 kt of carbon
Carbon burnt in the 0.1 degree cells (about 10 km) around the fire, from 7 October 2026 to 22 October 2026. An order-of-magnitude estimate from GFAS (ECMWF, Copernicus CAMS): it also counts neighbouring fires in the same cell. Contains modified Copernicus Atmosphere Monitoring Service information (2026).

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 18 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
23 October at 14:0251 MW1Met12
23 October at 13:5253 MW2Met12
23 October at 13:4254 MW2Met12
23 October at 13:3293 MW4Met12
23 October at 13:2271 MW3Met12
23 October at 12:5313 MW1N21
22 October at 14:104 MW1N20
22 October at 13:4913 MW1N
22 October at 13:1310 MW1N21
21 October at 01:356 MW2N
21 October at 00:596 MW2N21
21 October at 00:164 MW1N20
20 October at 16:4213 MW1Met12
20 October at 16:3212 MW1Met12
20 October at 16:2216 MW1Met12
20 October at 15:5210 MW1Met12
20 October at 15:2211 MW1Met12
20 October at 15:1211 MW1Met12
20 October at 15:0229 MW2Met12
20 October at 14:5212 MW1Met12
20 October at 14:3212 MW1Met12
20 October at 14:2725 MW3N
20 October at 14:2212 MW1Met12
20 October at 14:1230 MW2Met12
20 October at 14:0443 MW1Met9
20 October at 14:0257 MW3Met12
20 October at 13:4963 MW7N21
20 October at 13:4213 MW1Met12
20 October at 13:2256 MW4Met12
20 October at 13:1270 MW3Met12
20 October at 13:06166 MW6N20
20 October at 13:0491 MW1Met10
20 October at 13:04112 MW2Met9
20 October at 13:02110 MW4Met12
20 October at 12:5257 MW3Met12
20 October at 12:4552 MW7N
20 October at 12:4247 MW2Met12
20 October at 12:2234 MW2Met12
20 October at 12:1247 MW3Met12
20 October at 12:0214 MW1Met12
20 October at 11:3250 MW3Met12
20 October at 10:1212 MW1Met12
20 October at 09:5212 MW1Met12
20 October at 01:182 MW1N21
20 October at 00:331 MW1N20
19 October at 13:2517 MW2N20
19 October at 13:0610 MW1N
19 October at 12:2817 MW1N21
19 October at 00:541 MW1N20
18 October at 15:2517 MW1Aqua
18 October at 13:4532 MW4N20
18 October at 13:2324 MW2N
18 October at 12:4718 MW2N21
17 October at 14:0451 MW4N20
17 October at 13:0643 MW4N21
17 October at 01:313 MW2N20
17 October at 01:123 MW2N
17 October at 00:335 MW3N21
16 October at 14:2111 MW1N20
16 October at 14:0243 MW5N
16 October at 12:437 MW2N20
16 October at 01:502 MW2N20
16 October at 01:295 MW5N
16 October at 00:542 MW2N21
15 October at 15:06165 MW2Aqua
15 October at 14:218 MW1N
15 October at 13:4557 MW6N21
15 October at 13:00103 MW6N20
14 October at 13:1910 MW1N20
14 October at 13:004 MW1N
11 October at 13:557 MW1N
11 October at 13:196 MW1N21
10 October at 14:1415 MW3N
10 October at 13:3832 MW4N21
10 October at 12:5312 MW2N20
8 October at 13:325 MW1N20
8 October at 13:135 MW2N
7 October at 13:4913 MW1N20
7 October at 13:3220 MW3N

8 other fires near Tete (MZ)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2