Fire near Veracruz (MX)

18.51°N, 96.14°W · first detected on 19 October at 15:40

Permanent heat source, probably industrial: this is not a forest fire. A site that heats up day after day in the same place (factory, gas flare, steelworks, oil field) is seen by satellites as a hotspot. This page stays available, but this hotspot is counted neither in the list of the largest fires nor in the hectare totals.

What the satellites measured

This fire was tracked from 19 October at 15:40 to 22 October at 09:36, that is 3 days, through 11 satellite detections. The detected extent reaches 126 ha.

Detected extent
126 ha
Cumulative power
49 MW
Peak power, one pixel
7 MW
VIIRS and MODIS detections
11

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 5 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
22 October at 13:0021 MW1G19
22 October at 12:5318 MW1G19FRP
22 October at 12:0918 MW2Aqua
22 October at 10:390 MW1N21
22 October at 10:3318 MW1G19FRP
22 October at 10:0320 MW1G19FRP
22 October at 10:0326 MW1G18FRP
22 October at 09:5620 MW2N20
22 October at 09:5329 MW1G18FRP
22 October at 09:3553 MW8N
22 October at 09:3029 MW1G19
22 October at 09:2026 MW1G19
22 October at 09:1326 MW1G18FRP
22 October at 09:0319 MW1G19FRP
22 October at 09:0326 MW1G18FRP
22 October at 08:5335 MW1G18FRP
22 October at 08:5325 MW1G19FRP
22 October at 08:5038 MW1G18
22 October at 08:5028 MW1G19
21 October at 14:4323 MW1G19FRP
21 October at 14:4028 MW1G19
21 October at 13:5033 MW1G19
21 October at 12:3323 MW1G18FRP
20 October at 10:352 MW2N20
20 October at 10:132 MW1N
20 October at 09:3518 MW4N21
20 October at 09:1329 MW1G18FRP
19 October at 15:5020 MW1G19
19 October at 15:4323 MW1G19FRP
19 October at 15:4026 MW1G19

2 other fires near Veracruz (MX)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2