Fire near Volgograd (RU)

48.50°N, 44.62°E · first detected on 19 October at 00:16

Permanent heat source, probably industrial: this is not a forest fire. A site that heats up day after day in the same place (factory, gas flare, steelworks, oil field) is seen by satellites as a hotspot. This page stays available, but this hotspot is counted neither in the list of the largest fires nor in the hectare totals.

What the satellites measured

This fire was tracked from 19 October at 00:16 to 23 October at 00:59, that is 4 days, through 22 satellite detections. The detected extent reaches 229 ha.

Detected extent
229 ha
Cumulative power
25 MW
Peak power, one pixel
2 MW
VIIRS and MODIS detections
22

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

The detected extent

Outline of the burned area near Volgograd (RU), drawn over satellite imagery
The outline is the union of the ground footprints of every satellite detection of this fire, from the first pass to the last. The background is the EOX cloudless Sentinel-2 mosaic, 2024 vintage: it shows the landscape BEFORE these fires, not the burn scar.

The spread, pass after pass

  1. Volgograd (RU) seen by Sentinel-2 on 25 July

    25 July

    before the fire

  2. Volgograd (RU) seen by Sentinel-2 on 30 July

    30 July

    during

  3. Volgograd (RU) seen by Sentinel-2 on 1 August

    1 August

    during

One image per usable Sentinel-2 pass, on the same framing throughout so that the comparison means something. The satellite comes back every two to five days and clouds rule out some of the passes: the gaps in the series are days without an image, not days without fire.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 7 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
23 October at 02:221 MW1N
23 October at 00:591 MW1N20
21 October at 01:371 MW1N20
21 October at 01:182 MW1N
21 October at 00:421 MW1N21
20 October at 23:572 MW2N20
20 October at 01:562 MW2N20
20 October at 01:373 MW2N
20 October at 00:591 MW1N21
20 October at 00:161 MW1N20
19 October at 02:161 MW1N20
19 October at 01:561 MW1N
19 October at 01:201 MW1N21
19 October at 00:351 MW1N20
19 October at 00:162 MW2N

7 other fires near Volgograd (RU)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2