Fire near Santiago del Estero (AR)

25.84°S, 64.09°W · first detected on 20 October at 18:00

What the satellites measured

This fire was tracked from 20 October at 18:00 to 22 October at 07:29, that is 2 days, through 18 satellite detections. The detected extent reaches 460 ha.

Detected extent
460 ha
Cumulative power
112 MW
Peak power, one pixel
42 MW
VIIRS and MODIS detections
18
Estimated emissions
62 t of carbon
Carbon burnt in the 0.1 degree cells (about 10 km) around the fire, from 20 October 2026 to 21 October 2026. An order-of-magnitude estimate from GFAS (ECMWF, Copernicus CAMS): it also counts neighbouring fires in the same cell. Contains modified Copernicus Atmosphere Monitoring Service information (2026). Published data stop on 21 October 2026.

These four figures cover the polar orbits alone, the ones that measure an area. The pass table below also counts geostationary detections, more frequent but too coarse for geometry, and its power column sums a whole pass where the peak above is that of a single pixel.

“Detected extent” is not “burned area”: it is the union of the ground footprints of the satellite pixels, and a pixel counts in full (375 m for VIIRS, 1 km for MODIS) even when only a forest edge is burning. Compared with press figures it is in practice one and a half to three times the area reported. Detections taken at the edge of the scan swath, too coarse to measure anything at all, are excluded. These figures come from thermal detection and are not an official assessment: only the emergency services and the competent authorities are authoritative.

Replay how the fire spread

The map is framed on this fire's footprint and loads only its detections. The timeline below covers the period in which satellites saw it, from the first to the last detection, with twelve hours before and twenty-four after; the ticks on the bar mark the emergency services' announcements that fall within it. The cursor opens on the most powerful pass, and playback replays the whole fire in about thirty seconds. “1 h” shows what is burning within an hour of the chosen moment : the map then follows the power curve below and empties when it falls. “24 h” stacks twenty-four hours : a fire stays visible between two satellite passes, which come two to four times a day. Both are true, but they say different things.

How the radiative power evolved

One point per satellite pass: the sum of the fire radiative power measured over the fire. This is the curve that says whether the fire eased off or picked up again, which no cumulative figure shows. The window covers 4 days; beyond that, clustering would merge two successive fires in the same place.

Fire dynamics

Loading history…

Satellite passes in detail

PassPower summed over the passDetectionsSensor
22 October at 07:298 MW4N21
22 October at 06:468 MW3N20
22 October at 02:4818 MW1Terra
22 October at 01:2728 MW1G19FRP
22 October at 01:0735 MW1G19FRP
22 October at 01:0042 MW1G19
22 October at 00:5726 MW1G19FRP
22 October at 00:4785 MW2G19FRP
22 October at 00:4059 MW1G19
22 October at 00:3763 MW2G19FRP
22 October at 00:2779 MW2G19FRP
22 October at 00:17119 MW2G19FRP
22 October at 00:07112 MW2G19FRP
21 October at 23:57108 MW2G19FRP
21 October at 22:1060 MW2Aqua
21 October at 14:406 MW1Terra
21 October at 07:485 MW3N21
21 October at 07:044 MW3N20
20 October at 23:3028 MW1G19
20 October at 23:0035 MW1G19
20 October at 22:5041 MW1G19
20 October at 22:3056 MW1G19
20 October at 22:2070 MW1G19
20 October at 21:5057 MW1G19
20 October at 21:4057 MW1G19
20 October at 18:0038 MW1G19

8 other fires near Santiago del Estero (AR)

Separate fires, apart in time or in space, not pieces of this one. A single municipality can have several over one summer, and a forest massif often covers more than a hundred square kilometres.

Follow live

The map shows active fires in 3D, with smoke plumes, forecast wind, drop zones and the live position of water bombers tracked by ADS-B, anywhere in the world.

Open the fire map

Take the data of this fire with you

A ready-to-use archive, paid once, no subscription. It contains:

From €20.00 excl. VAT, six formats to choose from, link valid for 30 days.

Download the data

Pro subscribers: included. €49 excl. VAT a month, no commitment. The public map stays free. Discover GISFire Pro

© 2026 SARO · Gistin. All rights reserved. The interface, its presentation and the contents of GISFire are protected; reproducing or imitating them requires written permission. The source data remain the property of their respective producers, see the credits.

Legal notice · Privacy policy ·  · GISFire v2.4.2